In-Groove Engraving Bits

Question, Has anyone used these for Carving Logos? And is there a certain way I should set them up in Library? I have to Carve the NY State Police Log and I picked up the following:
Amana Tool RCK-363 Solid Carbide Insert 30 Deg x 0.030 Inch V Tip
Amana Tool RCK-383 Solid Carbide Insert 60 Deg x 0.030 Inch V Tip

So I was curious if anyone has experience with these tips and how to set them up.

Thank you all for your help!

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.