Inlay toolpath efficiency

[mhotchin (Michael Hotchin)]

I put this in as a feature request about 2 months ago, it didn’t get much interest at the time.

Inlay Plug Mode - no need to Vcarve the outer perimeter

When using the Advanced VCarve Inlay Plug mode, right now the outer perimeter is VCarved. The outer perimeter is not part of the plug. No need to VCarve it, the clearing bit can run right to the perimeter. For example, here is an inlay plug with the clearing bit disabled (only for demonstration purposes): [image] The outer edge could just be the clearing bit. Also, if Inlay Plug mode is selected, then there should be a warning if the clearing bit is disabled.