Issue setting F360 parameters for 3D Adaptive Clearing

[neilferreri (Neil Ferreri Ω)]

@gunter511

Should that be less?

Most likely. You can take deeper passes if this is lower.
Take a look at this thread:

Lets share some tool paths - 3d aluminium machining

I gave it a go last night. [IMG_20181014_013149] The top surface is smooth as glass. I should’ve measured my stock thickness better as I cut through on my adaptive pass, so I had to hit stop before that finished, but I was able to cut it out with my last contour operation. I’ll need to face the other side to clean it up, so it will end up a bit shorter. I went a little deeper just because I thought I should be able to. I might try another go with an even deeper DOC with a smaller load. I…