J Tech laser (OPT Laser)

Not sure what I’m doing and what pictures are being sent and to where they are ending up.
I’ve been in communication with the OPT laser people and I sent them a picture of the control board. They inturn sent back pictures of exactly where the wires are to be connected. Also they have produced a new wire that has the correct ends to connect to the posts showing in the picture. I hope this makes sense and is of some help.

If you will contact the address show they will send you that connection wire. They have been extremely helpful and realized they needed to make a better how-to video

This topic was automatically closed after 30 days. New replies are no longer allowed.