Lighthouse Carve

Carved this out today 10"x10" still need to add the finish.Maybe some paint.

10 Likes

Can you give details on how you did this? Software used (image, gcode, sender, etc), end mills used, time to carve? I’m interested in doing some carvings but not sure where to start , especially on the software side. I need to get proficient at 2D first, but I’m always looking for my next challenge. :slight_smile:

that looks great, the detail is excellent!

1 Like

Vcarve for software and carbide motion for the controller. 1/4 endmill for the rough and 1/8 ballnose for the finish.Took 3 hrs total.Got the stl for the model from this group on facebook https://www.facebook.com/groups/2506419786041062/

2 Likes

Thanks Stuart! …