Mach3 for Namad 883

Hi
I am planning on changing over to Mach3 to run my Nomad 883. I will be using a Pokeys 57cnc over eithernet to drive the steppers with Pokey stepper drivers.
Would any one know what the stepper drive current should be set at or what model stepper motors are being used?
Also, what the lead screw pitch might be?

Steppers are 2A, the lead screw is an 8mm pitch.

Hey @captjack - I’m planning on doing the same thing with my XXL. Did you ever get around to doing this? If so, how did it go?

are you thee Captain Jack PUA?

lol, I had to look that up…