MC Etcher Setting Speed

[briandobo (Brian)]

The lasts time I used the MC etchers, it measured on the Bitsetter and then immediately went into carving from the measurement. Now it is asking me to set the speed to 1rpm and speed of 1.
I assume that a different version changed this.
I just want to confirm? If so, what version of Carbide Motion made this change? I am running 622.

[WillAdams (William Adams (Carbide 3D))]

The current beta of Carbide Create allows setting an RPM of 0, and the M.C. Etcher is defined thus:

Carbide Create Beta Downloads

[briandobo (Brian)]

Could the included angle of the MC Etcher be added to this screen so as to know before going into the selection button?

[wmoy (Winston)]

I updated our tool database, but I need to bug our programmer to recompile everything for Create. Hopefully will get that sorted in the next release or two.