Motor Shaft Extension ER Collet

[WillAdams (William Adams (Carbide 3D))]

For an example of this see:

Makita RT070XX with an ER16 Collet Chuck? Yup

Story TIme… A long time ago… I raised my Shapeoko XY, and Z (rails) about 1.5625" (lol) inches. This was AWESOME because I run a lot of larger parts AND this ALSO meant that the Z would clear my 4th-Axis’ 4.0" (100mm) 4-Jaw, BUT this also meant that I could no longer reach my aluminum table. [IMG_6847] When needed, I would place a 3/4" plywood on top of some 123 blocks…not great, but it worked; however, I longed for my beautiful ultra-flat aluminum table. …then a few weeks ago I saw a post…