After opening the box and going through the inside boxes which are deferent than the assembly guide on the website.
1 - all the sliders are assembled
2- the wast board are one piece not Two.
3- the straps that come under the wast board not included. (1,2,3 in the next image)
4- router mout: I can’t mount it because x-z are assembled. I think de-asseble z to mout it.
Any one can guide me to a link for latest assembly guide.
This is much better.
I am still waiting reply from the support about the missing parts which is not clear in this assembly guide
Thanks for the link.
I think what makes the confusion most is the missing parts (straps under the wastboard )
I’m waiting a reply from support@carbide3d.com
Apparently those aren’t needed w/ the one piece wasteboard.
If that is the case why there is holes in the middle. Also the wasteboard could sag with time
Holes are probably from the same part also being used for the XL and XXL variants.
Span isn’t that wide — should be fine — check in w/ support?
