Has anyone tested if there a difference between blue, green and ordinary brown masking tape?
I use that old cheap tannish colored stuff. I run 3 strips of tape longwise along the edges and in the center of my part and then match that position on my spoilboard (6 strips of tape total). I then add a drop of thick CA every 2 or 3 inches along the tape on the spoilboard and finally marry up the tape on both items, holding it in place until I feel that it’s secure. I’ve not had a problem with it holding and I can ‘pry’ my part free without too much effort after the cut is done.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.