Pocket around stars

[neilferreri (Neil Ferreri Ω)]

@rbevers

What would be the best way to accomplish this?

Best answer, use different software.
V-Carve, F-Engrave, and Easel can all do this easily.

In Carbide Create:

Carbide Create V-Carve not working properly for small bits?

Math. I don’t use CC, but I’ve done similar in Fusion 360. Knowing your desired depth, you could create a path offset the radius of your end mill at that depth. Create a contour on that path with your v-bit. Use a pocket to create the flat in between. (Doesn’t keep me from complaining about it…my computer is better at math than me, so why isn’t it doing this for me?)