Hello,
I need to create a piece where the top side is not flat but has an angle.
I am searching, with CC Pro, how to create that toolpath.
I tried with a pocket, but how to tell the machine that my bottom should not be flat but has an angle?
Any idea for me? 
Thank you
.d
You could do this with 3D Modeling, and cut with a ball mill with 3D toolpaths, but you’ll have scallops.
If the angled surface is flat, I would consider tipping the workpiece using a sine plate or some wedges.
If the workpiece is small enough you could turn it side ways & cut the angle that way.
I was on that idea, tipping the workpiece using a sine plate, but I have some pipe to be drilled too
Drill first, then tip.
This topic was automatically closed after 30 days. New replies are no longer allowed.
