Pro pauses and prompts every times the VFD changes speeds

[tonytee (tony ter neuzen)]

I have a Pro with carbide VFD, and its a blast!

But somewhere in the beginning i made a stupid edit in a config file that resulted in the machine pausing and prompting for a “speed change” every time.

The speed change does not need to be done manually, the VFD listens to the controller perfectly.

Again, I broke it myself, but needless to say i forgot in which settings file and where.

Any1 know where that config file resides, or could you point me the way to reconfigure the machine so this doesn’t happen anymore?

I am a bit hesitant to just config “a new machine” because i remember it cost me quite some time to get VFD, bitsetter, spindle kit and xy config right.

It’s just that pesky pause/resume

Well… thanks… and sorry

Tony

[WillAdams (William Adams (Carbide 3D))]

Click on the version number in Carbide Motion, then in the “About…” dialog box click on “Open Data Directory”

[tonytee (tony ter neuzen)]

@WillAdams thats golden!

thanks for the shortcut that was obviously right in front of my nose

i can’t remember getting there before via this shortcut, this makes life a lot easier.
i remember digging deep in directory structures before.,.

cheers,
i got it back the way it should be…

tony