Probing at the upper left corner

[shane030716 (Shane)]

Not sure how hard it is for the developers to add this feature, but it would be nice to be able to use the touch probe at the upper left corner.

Thanks

[LiamN (Liam Newcombe)]

You’re not the only person who thinks more versatility in probing would be good…

Improvement request for Probing

Hi, we need to cut half of a long board which will hang over the front. Because of this we would like our X/Y zero position to be the top-right corner of the board. However, the probing block always probes toward X+ and toward Y+. It would be nice if Carbide Motion would allow us to probe toward X- and Y- and for that matter each direction should be independently choosable, so that all four corners could be probed. Thanks.

[Lonnie_Mac]

Howdy. This is a feature that would be great! I had no idea that you could select upper left corner in Carbide Create, and then send it to CM and crash your bit on the bit zero because I didn’t have my head wrapped around the idea that there is no upper left corner in CM.