I’m in the process of making a Puerto Rican flag. Overall dimension is 2’ x 3’. If you don’t know this flag,
there is a blue triangle that houses a white, five pointed star. In my case the star will be about 8" diameter around the points. Right now the triangle is solid blue that I will rout out to make the star white. I’d like to do the points with a V bit so they are sharp, but obviously that wouldn’t work well for the whole star.
My question is, is there a toolpath I can set up to just do the points to a depth of about 2mm, then switch to a 1/4" end mill to rout the remainder - also to 2mm? Or would I be better off getting a 1/32" end mill to do the points and then switch to the 1/4"?
Thanks for the help!
Stan