Question about cutting a round bottom slot

[Julien]

This thread might be useful, cigar tray using CC Pro

Stop full depth rough pass

so i’m new to carbide create and in spite of trying to read as much as i can, i can’t figure out why carbide either leaves this unfinished or decides to cut full depth of the material. i’m trying to make an ashtray and i’ve merged the center section but for what ever reason when i do the 3d rough / finish options, it either doesn’t finish ONE of the slots for the cigars OR decides to cut all the way down into the stock depth. check out these screen shots. i JUST want the section for the ciga…