Question on electrical circuit needed for a Shapeoko 5

[dandwolfwooddesigns (Dan)]

I am considering a Shapeoko 5. How many amps does a Shapeoko 5 draw? and how many does the compact router draw?

I have a fein turbo 1 vacuum that draws 9amps.

Can I safely plug in the shapeoko 5, dust collector and compact router on one 15 amp circuit or should I use a 20 amp circuit?

[WillAdams (William Adams (Carbide 3D))]

As noted at:

https://carbide3d.com/shapeoko/shapeoko5pro-specs/

Amperage 4A (Machine Only)

The compact router:

Circuit amperage

Good point Gary. I assumed that if the wire were 14 gauge the breaker would be 15 Amp. If a real electrician originally installed the circuit it would be a 15 AMP breaker, 14 Gauge Wire and a 15 AMP outlet. Many times home owners have a 20 AMP plug and simply change the outlet. Most appliances that have a 20 AMP plug dont really pull the full 20 AMPs and you may be able to get away using a 20 AMP plug on a 15 AMP circuit. The point of our advise is to inspect the outlet and fix if necessary…

should draw ~11 Amps at peak, so a single circuit won’t work.

At a minimum it’s best to have:

• machine and computer on one circuit
• vacuum and trim router/spindle on a second

If possible, put the vacuum and trim router on separate circuits for a total of 3.

[bradduffield (Bradley Duffield)]

there I have 2 questions
Basically when in CM I click on MDI then type in
M3s10000 it comes up busy straight away then everything I type into mdi same thing happens busy
I’m hoping that the second problem is related to the
First
When I push round button on vfd the spindle starts and and goes up in speed the display reads 400.0
So I have no clue what that is in rpms the stop button turns it off but the run button does nothing is this because it’s the brand vfd so I shouldn’t be pushing the run button
Really red your help