So I’ve really been having some fun learning here and I can’t thank you guys enough for the direction on all this. What I’ve done so far:
Using the links above, I found an STL project that was close enough to what I was trying to do:
I downloaded the STL2PNG program and ran that on the parts of the plane and then opened it in Create, which is where I learned about the Invert feature to take the male PNG files and turn them into a female mold project.
I did the cut, but I only had 3/4" MDF and not 1" and it went through the bottom because for some reason the section of the wing is down like 1/8" from the top of the MDF? You can see it from the last photo on the imgur link above.
Overall I consider it a big move in the right direction, I just don’t know why it’s starting the cut so low.
I don’t know how to post the STL file I used, but it’s at that GASB ONE project above.
I will say it came out way better than my corona DIY haircut…
Thanks again,
Chip-