Does anyone know how to get relative positioning gcode out of makercam or jscut or anything like that? I have my SO3 setup to start at 0, 0 but need code to be repeated. I have tried using offsets but they don’t seem to be supported by CM.
Thanks.
Does anyone know how to get relative positioning gcode out of makercam or jscut or anything like that? I have my SO3 setup to start at 0, 0 but need code to be repeated. I have tried using offsets but they don’t seem to be supported by CM.
Thanks.
There are some gcode tools in the wiki to do this (arrays of parts, etc) I think.