Requesting guidance to begin

[WillAdams (William Adams (Carbide 3D))]

Naturally, everything should be covered at:

https://my.carbide3d.com/

and

Carbide 3D

and the community (well, @Julien ) wrote up:

Introduction | Shapeoko CNC A to Z

and for Carbide Create I did:

• https://willadams.gitbook.io/design-into-3d/2d-drawing
• https://willadams.gitbook.io/design-into-3d/toolpaths
• ​https://willadams.gitbook.io/design-into-3d/3d-modeling-from-2d-geometry

as well as:

Keyboard Shortcut Cheat sheet for Carbide Create and Motion

Hope this helps! [Carbide3D_create_motion_keyboard_shortcuts_CM5_CC6] Updated version for Carbide Motion 5 (note that keyboard shortcuts have not changed for CM6) and Carbide Create 6 (updated for 627): Carbide3D_create_motion_keyboard_shortcuts_CM5_CC6.pdf (665.0 KB) For folks who only use Carbide Create or Motion: Carbide3D_create_motion_keyboard_shortcuts_CM5.pdf (661.1 KB) — as noted above, this still works for CM6 Carbide3D_create_motion_keyboard_shortcuts_CC6.pdf (573.3 KB) and Car…

and there is also:

Tips and tricks for Carbide Create

There have been a couple of instances of folks asking for things in CC which are already present. To that end, this thread will be a collection of tips and tricks and shortcuts.

More content would be welcome, and we look forward to you sharing your thoughts and experiences.