Settings for inlay plug

[WillAdams (William Adams (Carbide 3D))]

How thick is your stock?

What angle tool are you using? How is it defined?

Did you try the settings from:

Inlay Update in Carbide Create

We just posted an update to Carbide Create with a rework of the inlay mode. This is a fundamentally different take on how to make inlays, so inlay toolpaths created with the old code will be reset back to a basic Advanced V-carve in this build. You’ll need to reenable the inlay mode and set the new parameters. You can grab 777 here: Download Carbide Create V7 Here are a few of the test pieces we’ve done with bamboo and walnut (with zero special effort spent in setup or machining): [before…