Shapeoko 4 xl Belts Question

Gang,

I received my 4 xl in today, successfully assembled it. A little surprised that there were no instructions, but that’s ok, I probably wouldn’t have read them anyway. I watched the 16 minute overview video on YouTube.

Looks like the xl comes with the same pieces as parts as the xxl just with shorter rails and table. If that’s the case, am I expected to trim the belts? Before I go crazy and do something stupid it wanted to double check. Right now I have them kinda sorta tucked out of the way. But I can’t imagine running a job when them configured this way.

Any feedback out be appreciated.

I suspect you were shipped a set of XXL belts.

Cutting them is okay, but check in and let us know about this at support@carbide3d.com

1 Like

All of the hardware was marked xxl. So I think I ended up with a bunch of extra bolts and the like. On thing I’ve yet to figure out is the little square doohickey with 3M take or something on the back. Any thought on that one?

I glad its a case of too many parts (and long belts) and a whole baggie labeled “extra parts”.

What is the factory length for the two y belts?

Please write in to support@carbide3d.com about all this and we’ll do our best to answer there.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.