Shapeoko can't do ramp on curve?

[Julien]

Oh, also just saw this:

Warning: Bad gcode after Vectric Vcarve 10.5 Update

Did a fairly simple design for a birthday present. Went to cut it and GRBL barfed on the gcode. Tried both Shapeoko and GRBL back-ends. Same problem. …and of course Vectric doesn’t have backward compatible files so I had to cut and paste into 10 which generated valid gcode. Reported it. I’m staying away from 10.5 for a while.

Maaaaaybe they released 10.5 a bit too fast