Shapeoko Pro Fences - Show and Tell!

[Samcraft (Sam)]

I just finished putting a simple fence on my Pro yesterday and love it already! It makes material loading & setup so easy. Knowing that my material is square to the machine every time also gives me peace of mind to model my jobs to the fringes of my stock without worry of blowing through it. This cuts down on waste big time. Here’s my fence and build video. https://youtu.be/OMSx9-EXSA0

Anyone else put a fence on their Pro yet? Reply with pics/videos if so!

[Intohouse (Brandon)]

Sam…I posted this a while ago and it goes into the standard screw holes in the MDF slots

Corner Square that attaches to Stock MDF Wasteboard Holes

Hey Guys… I needed to cut 33" squares out of 34" MDF stock, which meant I needed to make sure that I was always using the maximum cutting space of the bed. My solution was to create a corner square, that would go in the top corner of the Shapeoko Pro Bed where the router couldn’t reach. [IMG_9569] The square attaches to the three top bolts on the x-axis and the two top bolts on the y-axis. I used M6-40mm screws to attach the corner square to the wasteboard https://www.homedepot.com/p/Everb…