When cutting stars on US flag which bit does a better job? 60 degree or 90 degree? And why?
@KevBarn14 did a practice run showing some different styles and things may be worth a look.
1 Like
Also if u search the forum there is over 50+ discussions about flags and stars ect… lots of knowledge and viewpoints out there. For me i prefer a 60 degree v bit as I feel it gives me sharper stars.
2 Likes
I had a woodworking club 2x4 contest back in Sept 2023. I used a 15 degree vee and 1/8" end mill with advanced vcarve and it came out pretty good. The material was about 24" wide x 12" tall.
cutrocket_amer_flag_outline.c2d (628 KB)
On the reverse side I put a straight flat
American_Flag.c2d (164 KB)
2 Likes
Wow. Thank you. Great knowledge and I truly appreciate it.
1 Like
No problem that is the best part of the forum… sharing experiences and articles. In the roughly 4 years I have been in the community 95% of this community is all positive and willing to share!
This topic was automatically closed after 30 days. New replies are no longer allowed.