Stl. aligment help needed

[WillAdams (William Adams (Carbide 3D))]

Wrote up a bit on this at:

3D Modeling from 2D Geometry | Design into 3D

and also see:

Modeling Instructions

OK…I can’t just let this drop. I started to experiment with the modeling and attempted to observe the behavior of the various parameters. I’ve begun to chart out those observations. This is, by no means, complete (and may even be inaccurate) and I would much rather have C3d developers post what’s really going on in the calculations, but here are my findings - so far. I cannot figure out what the real purpose of max and min are…and multiply SEEMS to have no purpose. I need to do more observati…