I read one of the old posts that gave me the measurements. I should put into my car by create. But when I go to measure it in car by motion, it gives me project will hit write of machine project will hit front of machine. See picture below, are there any suggestions of should I hit yes or no? In my CAD program, I created a material setup of X=1207mm(47.5”) Y=1234mm(48.5”). I Created a rectangle X=1230mm(48.4”) Y=1261mm(49.6”). I Centered this rectangle over the material. I am using a McFly cutter
I would suggest drawing up the machine structure using the rapid position points and jogging as described at:
and then working up a file based on actual interaction with the machine.
I would also suggest doing one slat at a time — it affords a bit more control, and is good practice.
I will give that a shot. Thanks
This topic was automatically closed after 30 days. New replies are no longer allowed.