My Surface Pro computer sits right in front of the tool change location, and it is sometimes triggered to disconnect by my clumsy huge hands while changing a tool. The computer cannot or should not be moved as the USB is at full length, and of course the electronics are mounted on that same side. Since this always happens on a tool change, I just make a new gcode file with the remaining toolpaths and start again from theree…but it is pretty inconvenient. Please consider…in future upgrades, to change the location back to the center or better yet give us control of that much like the bitsetter location (used to be?) Thanks… no hurry…and please advise if this already exists and I just don’t see it. cb heubach
A Y position in settings would be nice.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.