Tool Libraries for Import?

[WillAdams (William Adams (Carbide 3D))]

Not really.

Note that Amana sells quite a few tools which have geometry which is not supported in Carbide Create. While such tools can be used, one has to use a bit of imagination for previewing (or do w/o)

Using unsupported tooling in Carbide Create: Roundover / Cove / Radius bits

These are usually used in routers for decorative effects in wood: https://www.whitesiderouterbits.com/products/1570 but they are potentially useful for joinery: They are also useful for rounding off parts to allow rotary motion as for a hinged lid. Unfortunately, Carbide Create does not support this endmill geometry — but using the new support for previewing a V endmill when used in a No Offset Contour toolpath, it should be possible to preview them w/ confidence by stacking a series o…