Hey all…
New to the scene, here; one of my best friends and I picked up a new Shapeoko 5, and are starting to dive into the software. So far, so good (at least for me). BUT… last night I ran into an issue, where only some of the tool paths seems to have ‘taken’, because they don’t preview when you hover over the path on the list.
Now… the first four are drill - which highlight on the drawing as I hover over them - but the last three are V-carve, which don’t. When I run the simulation, the first four play along but then it stops after that. Reviewing the files shows I’ve got all the right parameters, with regards to bit and material, depth, etc.
What am I doing wrong?
Thanks…