Updated carbide motion and now probe dont work on xy but works on z

[randr (jason rosenstiel)]

I was way out of date on software updates so decided to update to latest and now the machine fails to probe “corner” I can probe “zero” but not x-y. I checked connections and all seems just fine.

Machine will move to start probing x but seems to fail when it should start going down but does move x properly just not down and back towards probe. Machine will stop and have to re-initialize but probe fails every time. Any ideas?

[Gerry]

It’s possible you have a BitZero v1 and the new Carbide Motion is defaulting to a BitZero v2, which has a different probe pattern.

Can you check your settings to make sure the right BitZero is selected?

[randr (jason rosenstiel)]

will check and report back. Thanks!

[randr (jason rosenstiel)]

@Gerry that was issue! thank you