Greetings. I am using CC to create a project. I have made two curved lines that start and end at the same point but with a different arc. Think something like an eyebrow. When I select the two lines in Toolpath, I set up my cut depth and speeds and tool, etc. When I OK the setup, the box reads “No Toolpath” and the simulation is blank.
Any way to pocket out the interior of two curved lines?
Hope this makes sense
Newby Bill
Hi @Superlucky
Welcome to the forum!
If you created the two arcs independently, chances are they are seen as two individual vectors:
Select both, and use the “join vectors” icon:
They should now be a single shape, and show up in black instead of purple,
and you should then be able to create your toolpath
If @Julien doesn’t have it, the problem may be that the curve is too small to admit the endmill you are using — try a V carving instead.
That was quick! Thanks to both of you.
Yes, the shapes are narrow, but I had been using a 1/16th bit. I do think the “join vectors” is the answer
Thanks
I just tried it and that did the trick
This Forum is great!
Bill
This topic was automatically closed after 30 days. New replies are no longer allowed.
