So today I go to use my machine and the VDF Spindle starts acting strange… The Botton is pushed in and the Red Ring is lit up, But when I go to initialize the machine the spindle starts to spin!! Never done that before. So I press the Stop/reset button and download the new Build for Carbide Motion and reset the Machine Shapeoko Pro XXL… so I initialize it again and then i go to set the BitZero V2. up to Do a Probe and “WHAM” the spindle comes on and Jerks the cable out of the control board… So now I’m at a loss of what to do. just sent an email into support. But has this ever happened to anyone before?
1 Like
That must’ve scared the 
out of you. Makes me appreciate my Makita router with its dedicated on/off switch.
1 Like
Very much So !! But it was more like WTF 
So I have wired the BitZero back together except for the Clip that goes on to the Control Board… I can’t find it any were. So I’m just waiting on Support to get back too Me.
It might still be attached to the controller 
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.