What's the trick to carving off an inlay plug?

[WillAdams (William Adams (Carbide 3D))]

While this was with the older inlay mode, I just use a pocket toolpath to cut away what is not wanted:

Inlay mode for Carbide Create

Lastly, the two pieces are glued together and then clamped. Then, we make a file to remove the waste from the inlay portion (the traditional way to do this would be to use a bandsaw or planer) inlay example — 4.5mm centered pocket bottom to remove.c2d (44 KB) 29 minute estimate in Carbide Create [WIN_20230301_20_45_19_Pro] also a 29 minute estimate in Carbide Motion, starting at 8:46PM