X axis crashes following belt stretch calibration

[WillAdams (William Adams (Carbide 3D))]

Max Travel is only headed if Soft Limits is enabled — the defaults have this set to off.

See:

Calibrating the machines over long distances

The typical technique for machine calibration: depends on precision measuring tools, and is limited by the reach of the tools in question. EDIT: It also depends on access to the MDI — if using Carbide Motion v6 it will be necessary to enable this in Settings | Options: [image] It should be possible to cut strips from a suitable blank of material, one along each axis — so we set up a square file which matches an available blank of material: [image] and put in suitable geometry and assig…

I don’t run out of travel on my calibrated SO3 XL w/ HDZ, nor can I recall running out on my SO Pro w/ Z-Plus.

Does it happen for Rapid Position movements?