I have noticed that my router does not move far enough in the Y-Axis to allow my bits to hit the center of the BitSetter button. It only moves far enough allowing me to only catch the end of the round button. This is starting to be concerning when running 1/16" bit or V-Bits. How can I get my Pro…

Y-Axis Does not move far enough to center over BitSetter

WillAdams (William Adams (Carbide 3D)) July 19, 2023, 6:18pm 2

Usually this is caused by the Y-axis belts (and by extension the X-axis) not being sufficiently taut.

See:

if that’s not the case, you can slightly increase the Y-axis Travel Dimension as necessary.