Here’s the place in “docs” where “clear all offsets” is addressed. Now, I remember reading this.
Because we are starting a new job, we need to clear any existing offsets.
1 Like
Dumb question: but what effect does pressing “clear offsets” after homing have when you are using the Bitzero probe to set your work piece zero immediately afterwards?
Well yeah, that’s what I’ve been trying to ascertain from this thread since I read it here.
Did you ever get the job to run?
I was able to run the job, Michael. And I was not able to reproduce the original problem. My best guess is…gremlins?
If it happens again I will be back.
1 Like
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.