Carbide 3D Community Site

Z not saving after power off/on

Software Carbide Motion

mhotchin (Michael Hotchin) February 12, 2025, 11:24pm 6

BUG - CM 640 - Z value incorrect until first use of BitSetter Carbide Motion

On machines with a BitSetter, the Z value is incorrect until the first use of the BitSetter. To repro: Initialize the machine, make sure you are using Workspace (not Machine) co-ordinates. Jog Z down and set Z Zero. Precise location not important. Jog Z to top of travel. Note Z value. Power down, close CM, i.e., behave as if done for the day. Power up, initialize. Jog Z to top of travel. Note Z value. On the ‘Run’ page, do ‘Load new tool’. Don’t actually change the tool, leave as is. Now …

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled