3D inlay, anyone know how?

[cnackers (Chris Nackers)]

Anyone ever done a 3D inlay?

I’m working on wavy flag project and i’d REALLY like to inlay the stars, but haven’t quite been able to figure it out. I typically use Vectric, but i do have Fusion 360 as well, but i’m not amazing at F360.

[CullenS (Cullen Simpson)]

Review this thread started by @fenrus

Topographic inlay

Ever since I saw the contest from @Radiation at https://community.carbide3d.com/t/community-challenge-28-return-of-challenges/ I wanted to do a design like this using the Carbide Create new inlay feature, but I never got my head around how to do this in time for the contest… but better late than never. [PXL_20230626_004454166] (note: although I show some of the steps below, this is no a tutorial. While I normally show a lot of the digital steps in great detail when I write tutorials… this one…