Adding Diamond Drag Bit to Tool Selection

[rnicolson (Ryan Nicolson)]

Welcome to the community.

I don’t have pro but assume it is similar. Click the edit menu and choose “Show Tool Database”
.
Right click on one of the sections in the database and select “NewTool → Vee Bit → MM or inch” and then fill in the relevant information in the box that opens up.

This thread may help.

MC Etcher Speeds, Feeds, & DOC

So, I picked up the pack of the MC Etcher engravers and just wondering some opinions on what people are finding to be good speeds and feeds. Yes, I’ve watched @wmoy video, which is primarily the reason for the purchase. I was more just opening up a discussion to see what’s working for everyone. I’m almost exclusively engraving powder coated aluminum, so that’s where my interest is personally. I’ve been testing around 100ipm and a .01 doc using the 90º bit (the 120º just doesn’t penetrate the pow…