Advanced V-Carve problem

[neilferreri (Neil Ferreri Ω)]

@Grapes4dinner

I will be left with just a big square bowl cut into my mdf, idk how to get around this

Here’s one way.

Getting the Pro Setup

Here’s my method for getting a raised area to level in the machine working area on the Shapeoko Pro: 1 - Make a leveling program for the workable area and level it the least amount possible. You’re basically looking to make marks on where to cut. I had to remove 0.020" to get it everywhere. I made a program that was an inch wider so my 1" surfacing bit would get as much as possible. I also numbered my slats so I wouldn’t mix them up. 2 - Scoot all of the slats forward a mounting hole to give y…