alandaily
(ALAN RAY DAILY)
March 5, 2025, 2:27pm
1
Good morning, I’ve been asked by someone at work to make this flag, the issue that I’m having is the advanced vcarve for their logo. I want it carve out so the black stays black but I get the opposite. What am I doing wrong or missing? Thanks
WillAdams
(William Adams (Carbide 3D))
March 5, 2025, 2:34pm
4
This is the “figure-ground-reversal” problem.
See:
This came in from support difficulty in getting a purchased image:
[image]
to cut as desired.
We will review the specifics here.
and
As requested on support…
Given a traced image:
[image]
which has a pocket toolpath which previews as:
[image]
One can ungroup it:
[image]
[image]
Select only the outer geometry:
[image]
and delete it (or move it to a different layer) to get a different appearance:
[image]
[image]
[image]
Ok
Then associate the inner geometry with the toolpath:
[image]
[image]
“Use current selection”
Ok
[image]
Because the geometry has sharp corners, one can get more detail using an…
1 Like
system
(system)
Closed
April 4, 2025, 2:34pm
5
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.