Advanced Vcarve for flag

[WillAdams (William Adams (Carbide 3D))]

This is the “figure-ground-reversal” problem.

See:

Figure ground reversal

This came in from support difficulty in getting a purchased image: [image] to cut as desired. We will review the specifics here.

and

Figure-ground reversal and toolpath considerations

As requested on support… Given a traced image: [image] which has a pocket toolpath which previews as: [image] One can ungroup it: [image] [image] Select only the outer geometry: [image] and delete it (or move it to a different layer) to get a different appearance: [image] [image] [image] Ok Then associate the inner geometry with the toolpath: [image] [image] “Use current selection” Ok [image] Because the geometry has sharp corners, one can get more detail using an…