As funny as a $3 dollar box

[WillAdams (William Adams (Carbide 3D))]

Alternative lid at:

Using unsupported tooling in Carbide Create: Roundover / Cove / Radius bits

These are usually used in routers for decorative effects in wood: but they are potentially useful for joinery: They are also useful for rounding off parts to allow rotary motion as for a hinged lid. Unfortunately, Carbide Create does not support this endmill geometry — but using the new support for previewing a V endmill when used in a No Offset Contour toolpath, it should be possible to preview them w/ confidence by stacking a series of V endmill cuts.

[WillAdams (William Adams (Carbide 3D))]

The above was done using v6, so here are updated files:

67b86d0d17056_67db6c161d026_v8.c2d (164 KB)
67b86d0d17056_67db6c9511a89_v8.c2d (80 KB)
67b86d0d17056_67db6c15d4053_v8.c2d (100 KB)
67b86d0d17056_67db6bf79d890_v8.c2d (264 KB)