Bit setter and flattening bit

[greg5 (Greg)]

This was my solution

BitSetter "hat"

My surfacing bit misses the button included with the BitSetter. I could not get the screws loose to disassembly and look at a complete button replacement, so I milled one that is a tight press fit over the existing button and catches my surfacing bit. The clear acrylic that helps see the LED protrudes, hence the 2 dimples. However, I’ve noticed that you can just pull that acrylic piece out, which I haven’t done yet since I know I’ll lose it, but as this covers the LED, perhaps I should just do …