I’m glad you like it. This is the first command to take advantage of a lot of the new plumbing we added a few months ago to make it possible for commands to be more visually interactive.
I’d also like to do that but there are cases where you cannot apply every possible fillet, because some would get in the way of others getting applied. In those cases, one or more fillets may not get applied.
I’m not sure if this option would cause a net gain or reduction in support problems, which will be the way we decided how to handle it.
We actually made some internal changes to the undo system with this in mind. It’s going to require a little more thought but I think we’ll probably get it done.
We’re also planning to add additional corner types once we get feedback here- chamfers, flipped fillets, dogbones, etc.