Carbide Create Beta 760

[TheWoodworker (Scott Hampshire)]

We have several posts documenting the same behavior that you can find here:

Ramping issue: Doing something strange

I have tried using the ramping feature many times but it does something strange that I do not know how to correct. When I turn on ramping it will raise the spindle/router about 1" above the workpiece after every pass/layer it cuts. So if I am cutting out a bunch of pockets that takes say 10 passes/layers per pocket, the spindle will raise up and back down 10 times for each pocket. A perfect example of how annoying this can be. I just ran a job today that had 96 pockets. That is a crazy amount o…

Ramping Pocket ToolPath Curiosity When Z-Zero Is Stock Bottom

You’re not the first one to notice this issue. I’ve been told it’s on their radar, but I’d still file a bug report to bring more attention to it.

Strange toolpathing during rest machining

So I’ll fully admit that this might be a total user issue as I’m just getting back to the software after letting things sit for a while due to life getting in the way, but I’m seeing strange toolpathing on a rest machining operation. I am pocketing out a bunch of hexagons from a 1/2" thick piece of material, first with a 1/4" bit and then ideally using an 1/8" rest machine operation, but when I run the gcode generation it produces an enormously long toolpath (over 1400 minutes). Upon closer ins…