Carbide Create Pro angled surface

[WillAdams (William Adams (Carbide 3D))]

1. You can change any of the settings in the STL import window

2. Z is set independently of XY scaling and may be set to any dimension which one wants.

3. You can set the 3D preview to use any of the material choices from the Toolpath 3D preview.

See:

Creating a project from an STL file

as requested on support… Given an STL file: [image] which one wants to cut out as: [image] one first loads it into Carbide Create Pro: [image] which previews in 3D as expected: [image] When an STL is imported, the perimeter will be traced: [image] Assuming one wants to cut around the 3D object, one offsets from this by endmill diameter plus 10% or so: [image] [image] It is then possible to assign a 3D roughing toolpath using this offset geometry: [image] [image] Then a 3…