Carbide Create Pro- What do you want to see?

[Derf (Steve Langenderfer)]

So, Carbide Create has a bug. Maybe you can fix this in Pro.

When adding tabs to a part, the plunge at the end of the tab is done at the feedrate, not the plungerate.

This is an easy fix. I just did it the hard way by modifying the G-Code for an aluminum sheet that I am profiling. Worked perfectly.

Tab plunge speed

Yea. I just came here to figure this out too. I have come to the conclusion that the plungerate for tabs stays at the same as the feedrate. Why doesn’t it use the plungerate? If I’m correct in this observation, this can’t be too big of a change for Carbide3D. A ramp would be sweet, but it would be a simple change to get it to honor the plungerate parameter we already specify. It would make a huge improvement (and eliminate a major frustration) for users that use tabs. I’ve been doing aluminum …