Carbide motion newest version

Okay I just down loaded the new version of carbide motion since I purchased the bit setter. How do I check and make sure the correct machine is set in carbide motion?

Please see:

Thanks WillAdams

Another question when I loaded the new version would I have to pick my machine again

Yes. The newer versions store many machine settings locally, so please configure everything, including Grbl (if need be, reset any customizations).

Where can I go to see what I need to do and how to refigure everything. All I did was load the new version. After I had installed the bit setter. Other then configure the bitsetter I didn’t do anything else.

This topic was automatically closed after 30 days. New replies are no longer allowed.